Forum User

Who do I contact to repair a DPO4034B?

How do I change the saved file format of a waveform screen capture on a TDS2014

Is there a 'US Government Regulation' hold when downloading KickStart from Tektronix?

Can the dotted line on the MSO46's screen, right under the triangle where the trigger position is, can be turned off?

How can I purchase a manual for the RTD720?

Hi,

I'm doing a study on including DMM6500s in an automated test equipment application to replace manual test procedures. Our current procedures use a clamp on current probe to trigger a o-scope when a DC inrush current rises above a specific level. I'm trying to see if the DMM6500 can be used in place of this current probe and have the following questions:
- Can you set the digitizing current function on the DMM6500 to trigger on the rising edge of a user-input threshold current?
- Would this waveform trigger generate a signal on the trigger output signal on the rear panel of the DMM6500?
- What's the time delay between the waveform trigger and the rear panel trigger output?
- Can the DMM be configured to perform this function using SCPI commands?
- Can the digitized buffer be read into a workstation using SCPI command?

Thank you,
Jeff

Is it possile to purchase the display lens 2700-311A as spare part?

How to connect a monitor to an MSO58LP?

I'm using a benchtop variable DC power supply operating in constant current short circuit mode, and a DMM measuring the current. Is it technically feasible to use a TCP 202A current probe connected to a MSO2024B using a TPA-BNC adapter, with 12V DC @1.5 ADC?

Has the TCA-1MEG been discontinued? If "YES", has it been replaced by a different product or is a different product recommended?