Forum User

Hello I am in need of the SDS and the UN 38.3 test results for the TDS3BATC battery. Thank you.

The screen on my DPO3014 is not working properly. The lights, fan, and screen all turn on normally while the device is booting up, but after a few minutes, the screen appears to turn off randomly. I've tried rebooting the device several times, but nothing worked. I'm used to seeing a power cycle when the device turns on but now the device instantly powers up once plugged into the wall. The unit was sent in for calibration in December, and this is the first time it has been turned on.

Is there a way to buy a TDS2022 screen to replace on my TDS2024?

I am having issues with my 4200's screen not working while the unit is running. Even after trying to connect it to the VGA port, it still won't display on an external monitor.

Please reach out to Drew regarding this issue.
Thanks

Is the TDS210 still supported for issues with the screen not turning on?

I am having a screen problem on the TDS2000. The internals appear to be fine, and can transfer memory through GPIB, but the screen went dark for no apparent reason. Since the TDS2000 was discontinued, what are some similar options for the unit? Is there a way to transfer code written in LabView for the TDS2000 to a newer unit?

The 2602 display keeps locking up. After configuring the output current and voltage, I've turned on the output to start running tests but noticed the display was frozen. I've tried resetting the unit, but after a minute the display would lock up again. This was all happening in manual mode. A month ago I noticed an error message on the unit which said something about a battery discharge. This was the first time using it since then.

I am wondering if there is a SCPI command to turn on the measurement result table similar to the Add New -- Results Table -- Measurements -- Add button presses.

Used to occasionally get a System Error upon boot, but as of this morning am totally unable to boot the scope.
Presently running firmware 1.38.1. I tried loading a USB drive with 1.40 and turning on power with tit inserted, but no avail.
Any tricks to try?

I've tried rebooting the scope a couple of times. Each time it shows me the main screen for less than a minute and then un-prompted returns to it's sleep mode and won't return to the main screen. I cannot use it. I've tried pressing all the buttons or quickly try to restore default settings before it shuts off again.