Forum User

Does the Tektronix DPO4104 have a removable battery? If so, is removal of the battery necessary to clear or sanitize the DPO4104?

In looking through the sanitization procedure (see attached), does "remove power" mean merely power down the the DPO4104, unplug it from the wall outlet, or remove a battery?

Hello,

I have misplaced my battery pack and was wondering if you can help provide me the part info?

Can you provide details on the type of battery used inside the DPO5104?

Is it true that the bandwidth of channels 3,4, 7 and 8 is limited to 5 GHz, even if it is only one channel turned on at a time? And that having one of these four channels on will limit all scope channels to be limited to 5 GHz? IOW, if we need the max bandwidth, we are restriced to using only channels 1,2, 5 and 6

I have a AFG3022C which I know is discontinued and want to know if the AFG31022 would work with the software and bench setup that I currently use.

Hello,
We currently have a AWG5208/825/8HV

Can you please confirm the DAC sample rate is 5GS/s and whether or not there is an option of getting a higher sample rate with this unit.

Also, is there an up-conversion option with this unit that allows the DACs to output at baseband and then upconvert to a carrier of my choice?

I know there is an option to upgrade the sample rate from 2.5 GS/s to 5 GS/s (10 GS/s interpolated), AWG5200-2-2550. Is this something that could be added to the above unit via license or is hardware also required?

Also regarding the up-conversion option AWG5200-2DIGUP, does it allow the unit to perform as the customer describes and is it upgradeable via license or is hardware also required?

Can you tell me what is the average power consumption of the MSO58 when it is in standby mode?

Can you suggest the closest equivalent unit available to replace a TDS794D Digital oscilloscope (4CH, 2GHZ, 4GS/S, 8M BW)?

Greetings,

Is the DPO4AUTOMAX Application Module still available?

I'm having trouble finding one...

I have a MDO3054 that began randomly triggering relay when I was performing measurements, with or without any input on the probes or change of settings. The relay has no effect on the result. It's an audible click when it triggers. Do you know what could be causing this?

Also, I we use the TPP0500B series probes with our oscilloscopes, and I notice that the scope says that “Termination is set by TPP0550B”. Am I correct in assuming that with a TPP0500B plugged in the operator should not be able to alter the termination manually via button or programming?