Forum User

My company is looking to purchase an oscilloscope that has glitch mode triggering and is capable of keeping a running count of glitches to display on the scope screen. In the past we've used the TDS6604 and were wondering what the best replacement might be. Most modern scopes only display trigger frequency, not running count, so we've been struggling to find a replacement.

Many of the functionality of this scope no longer responds to button presses (triggering, among others).
We are also no longer able to open most menus. The scope reports not passing a power-on self-test.

What is the replacement scope for the TBS1104, as this product is now obsolete.

When going to the IP address for the scope and clicking on "Instrument Control (e*Scope®)" to use the scope, nothing shows up but a white blank screen. All other pages work on the just IP page.

http://10.0.0.8/Tektronix/

This happens across all major browsers, chrome, firefox, and edge and the computer can access the scope etc. Firewall rules are allowing traffic.

The scope fails internal tests and startup test time scale is 20% off

We are performing SPC periodically, and per manual, it is asking to remove all input cables. I want to ask if you could give a bit more definition on what "input" means? Besides CH1, CH2, CH3, CH4, is necessary to remove cable connection to AUX IN, AUX OUT, and REF IN? Thanks

I have a TDS 2024C scope that on power on the screen is blue and then it goes blank. Do I have a bad screen or bad board?

Are schematics available for the DPO7254? Looking to check out Channel 2 on the DPO7254 to investigate problems with noise/dead range.

I have a TSG4100A and am curious if the device can generate radiofrequency electromagnetic fields of which I can control the frequency and power. I need to generate 1-3GHz RF fields for some research and I would like +30dBm output.

Hello, we currently are using the AWG 7000 with RF Express to create a NOMOP signal on the carrier (carrier < 5 GHz) with a pulse offset from carrier from -300 MHz to 300 MHz, PW from 200ns to 2000us & PRI from 200us to 5000us. We are replacing the old AWG with the new 70002b - which plug-in do we need to support this kind of signal generation? Thanks!