Tektronix Applications Expert

Accuracy specs for the TBS2202B can be found in this document: https://www.tek.com/en/manual/oscilloscope/tbs2000b-series-oscilloscopes-tbs2000-basic-oscilloscope

Hi,

The TCP0030A accuracy specs are as follows:

Accuracy, typical
DC: ±1% of reading

DC to 60 Hz, ≤5 A: ±1%

60 Hz – 5 kHz, ≤5 A: ±1.5%

DC – 5 kHz, >5 A: ±1.5%

The % of reading implies an accuracy within a percentage of the measured value. For example, a DC signal at 1A would have a +- 1% accuracy, meaning it would be accurate within 10mA. That implies a range of 990mA to 1010mA for the true signal value. A 1A signal at 1kHz would have 1.5% accuracy, implying a range from 985mA to 1015mA.

Hello,

The DSA71254C scope does not include probes. Probes are seperate and selected at or after time of purchase. Any replacement parts for the probes would be found in the user manual for the specific probe.

Thanks for contacting us,

The TPP1000 supports operating at temperatures up to 149 °F.

Hello:
Here is the link to the Instruction manual on tek.com:
https://www.tek.com/en/probes-and-accessories/high-voltage-differential-probes-manual-1

The manual has Specification, Performance Verification and adjustment procedures for the P5200A, plus a lot more.

Hello,

There will likely not be a large change in observed rise time using a 100MHz scope, since the scope is the limiting factor. The scope rise time should be around 3.5ns, while the TPP0200 probe is specified at 2.3ns typical.

The TPP0200 has 12pF input C, while the P6139B has 8pF. Depending on your system that may have a slight impact as well.

I hope that helps. Thank you!

Hello,

AC coupling is not available for triggering on those two models. Low Frequency Reject would be the closest option with these two scopes. The cutoff frequency for LF Rejection is 65kHz.

Hello,

Unfortunately, we do not specify the AC gain accuracy for this scope. Our full list of specifications is in the Performance Verification manual: https://www.tek.com/en/oscilloscope/mso4000-dpo4000-manual/mso4000b-and-dpo4000b-series-0.

Hi,

Please power off, and remove power then power back on and do a default setup to verify that the the unit passes the Self Calibration. From the Utility button "Do Self Cal".

Hi, I recommended the 2260B-30-108